Tag Archives: insulation

RV Ceiling Insulation

It was time to add some insulation to the ceiling of the van, now that with the Murphy bed installation, access to the ceiling is closing up.

poly-iso insulationI already made the decision to use primarily Poly-Iso and Denim insulation and started to fill the ceiling cross-members with Denim. The cross-members allow for approximately 1-1/2 inch insulation, when you follow the curvature of the roof. Continue reading RV Ceiling Insulation

Wall Panel Issues

It was time to make the final fit of the wall panel, that sits behind the Murphy Bed and that forms the background of a closet and side of the rear kitchen.

wall panel cargo vanThe length of the 8′ x 4′ (244cm x 122cm) plywood panel, is just shy of what’s needed to cover the rear window, but that is solved by extending the window support. The cut-outs for the ceiling cross beams fit tightly and the top corner, behind the driver’s seat, fits snuggly around the side airbag location. Continue reading Wall Panel Issues

Wall Panel – Part One

Watch all my videos on YouTube!

The wall panel on the driver’s side is partially hidden by the Murphy Bed, a closet and part of the kitchen. The main rear side window will be permanently hidden, while the front side window will be available when the bed is in use. The smaller rear side window offers exterior views from the rear kitchen.

The wall panels are temporarily installed, to allow for the fitting of all the components. Insulation and necessary cabling will be added before final installation.

plusnutTwo types of fasteners will hold it all together. A plusnut will keep the structural parts securely connected to the metal walls. They can hold the load of the bed, cabinets and content in place. Ordinary stainless steel rivets offer a secondary attachment method. Some of the visible parts of the paneling will also be covered with Formica. Continue reading Wall Panel – Part One

Spray Foam Floor Insulation

Laying a sub-floor in an RV consists of many individual steps. After removing the tie-downs, insulating the wheel wells, creating plywood templates, cutting and gluing the strips of Poly-Iso to the floor, I’m now completing the insulation by filling the voids with a spray foam application.

Although it is a closed-cell, waterproof foam, after cutting off the excess, what remains is susceptible to moisture, but still adds insulation and some structural cohesion to the floor.

As always, I have detailed every step on the Project’s Page, and added lots of pictures and a video.

Mod: Insulated Floor – Spray Foam Application

Continue reading Spray Foam Floor Insulation

Insulate Your RV Floor – Part Four

Gluing Insulation

Every RV should have Insulation and gluing it is the best way to keep it in place. As part of the Insulated Floor Project, I just finished gluing all the individual pieces of Poly-Iso insulation board between the floor ribs of the Ford Transit floor.

You can read about all the details, and view all the photos and videos on the project page. When the entire floor project has finished, the complete guide will be made available for download.

Your comments are appreciated. Tell us about your RV mods and how you did it, and we might publish your story.

Watch all my videos on YouTube!

Insulate Your RV Floor – Part Three

Cutting Poly-Iso

After having done the preparation by removing the tie-downs and by applying sound insulation to the wheel wells and preparing to cut the plywood by making paper templates. The next step is cutting the insulation boards.

cutting-poly-isoTypes and amounts of insulation have always been a controversial subject amongst us DIY’ers and in all probability there is not one right solution.

For me affordability, R-value and ease of installation are primary objectives, but as the interior height in my medium high roof van is limited, the amount of insulation material that I can put under the sub-floor is minimal. Continue reading Insulate Your RV Floor – Part Three